Weldbend Corporation
 
you are here: Home > Weldbend Catalog > Fittings > Reducing Tees (page 3 of 3)
Reducing Tees
STANDARD WEIGHT
Inches / Pounds

Standard Reducing Tee
For Metric Units >Click Here

Nominal
Pipe Size
Run/Branch		 Dimensions of Run Dimensions of Branch Pipe Schedule Weight in Pounds
Outside
Diameter		 Wall Thickness
(T)		 Inside
Diameter		 Center to End
(C)		 Outside Diameter Wall Thickness
(T)		 Inside Diameter Center to End
(M)
 
30 x 24 30.00 .380 29.24 22.00 24.00 .380 23.24 21.00 * 795
30 x 20 30.00 .380 29.24 22.00 20.00 .380 19.24 20.00 * 749
30 x 18 30.00 .380 29.24 22.00 18.00 .380 17.24 19.50 * 727
36 x 30 36.00 .380 35.24 26.50 30.00 .380 29.24 25.00 * 1,207
36 x 24 36.00 .380 35.24 26.50 24.00 .380 23.24 24.00 * 1,129
36 x 20 36.00 .380 35.24 26.50 20.00 .380 19.24 23.00 * 1,072
36 x18 36.00 .380 35.24 26.50 18.00 .380 17.24 22.50 * 1,136
42 x 40 42.00 .380 41.24 30.00 40.00 .380 39.24 28.00 * 1,468
42 x 36 42.00 .380 41.24 30.00 36.00 .380 35.24 28.00 * 1,415
42 x 30 42.00 .380 41.24 30.00 30.00 .380 29.24 28.00 * 1,327
42 x 24 42.00 .380 41.24 30.00 24.00 .380 23.24 26.00 * 1,248
48 x 42 48.00 .380 47.24 35.00 42.00 .380 41.24 32.00 * 2,207
48 x 38 48.00 .380 47.24 35.00 38.00 .380 37.24 32.00 * 2,154
48 x 36 48.00 .380 47.24 35.00 36.00 .380 35.24 31.00 * 2,127
48 x 30 48.00 .380 47.24 35.00 30.00 .380 29.24 30.00 * 2,048
NPS O.D. WALL I.D. CENTER TO END O.D. WALL I.D. CENTER TO END PIPE SCHEDULE POUNDS
  DIMENSIONS OF RUN DIMENSIONS OF BRANCH    

< Previous

  
 
* This Size and thickness does not correspond to any pipe schedule number.
  1. Dimensions conform to ASME B16.9 & material conforms to ASTM A-234 Grade B
  2. For bevel detail see page 50.
  3. For dimensional tolerances see page 51.
www.weldbend.com Copyright © 2002 by Weldbend Corporation. All Rights Reserved.