Dimensional Tolerances for 90º Elbows, 45º Elbows, Straight and Reducing Tees

Nominal Pipe Size	½ to 2½	3 to 3½	4	5 to 8	10 to 18	20 to 24	26 to 30	37 to 48
Outside Diameter at Bevel, D [Notes (1), and (2)]	+0.06 - 0.03	±0.06	±0.06	+0.09 - 0.06	+0.16 - 0.12	+0.25 - 0.19	+0.25 - 0.19	+0.25 - 0.19
Inside Diameter at End [Notes (1), (3), and (4)]	± 0.03	± 0.06	± 0.06	± 0.06	± 0.12	± 0.19	± 0.19	± 0.19
Wall Thickness, t [Note (3)]	Not Less Than 87.5% of Nominal Thickness
Center-to-End Dimensions of 90 Deg and 45 Deg Elbows and Tees, A, B, C, M	± 0.06	± 0.06	± 0.06	± 0.06	± 0.09	± 0.09	± 0.12	± 0.19

Notes:

Out-of-round use the sum of absolute values of plus and minus tolerances
This tolerance may not apply in localized areas of formed fittings where increased wall thickness is required to meet design requirements of para. 2.2
The inside diameter and the nominal wall thicknesses at ends are to be specified by the purchaser.
Unless otherwise specified by the purchaser, these tolerances apply to the normal inside diameter, which equals the difference between the nominal outside diameter and twice the nominal wall thickness.